takes up to 2 minutes which on black screen. Up until that point, i tried for 10 minutes to connect. As soon as I shifted the bend in wires to open clip fully, it very easily locked on. I thought I could press the clip on, but indeed you need the swinging action to properly close. Why this matters, you need to use a fully opened clip to lock closed. Over time, we will be transitioning to myLutronthe evolution of the Resource website, built to serve as your password-protected portal to for software downloads, training videos, marketing tools, and more. Since the wire harness is so thick, depending on your bend in the wires, the clip you opened may not have opened widely. For now, the software is still available on the RadioRA 2 Resource Website. I have read where its impossible to upgrade and also read it isnt so any tips would be appreciated.
Has anyone have any info that can help me.
Radio conversion Harness7 speed AC- single harness& AC/HVAC Control Module4 speed AC- 2 part Ha. The only piece I would share that isn't as obvious is the reconnect of the 52 pin wire harness back on the RA4. My tradesman 2013 has the ra1 radio and I bought a ra2 to try to make it work. 2014-2018 Ram RA2 to RA3 Radio UpgradeWhat you will need:1. The reason being is that with the super cold temps, I was told that pulling the bezel in the very cold, could crack the plastic.Ģ014+ Jeep Grand Cherokee Factory GPS Navigation Upgrade! Easy! Radio Removal Installation 2015 2016 I ran the heat in the vehicle for 10 minutes to warm up the vehicle. I purchased the radio from infotainment previously oemautopartco. Attached is the youtube that walks you through the entire process. entire process took 30 minutes because I was super careful with the vents from bezel to bezel.
Did the swap today of a RA2 - factory to a OEM RA4.
0 kommentar(er)
